INSTALLATION INSTRUCTIONS
Specifications: See back cover
Undo straps, lift carton off heater.
Never lift the heater out of the carton by the top louvres. Check for damage.
If unit is damaged, contact Supplier or Rinnai for advice BEFORE INSTALLATION.
Check unit supplied is correct for gas type in your area.
Refer to local gas authority for confirmation of gas type if in doubt.
Data plate is inside heater on left hand side.
Instructions
Back spacer and screws with wall brackets.
INSTALLATION-GENERAL
This heater must not be installed where
curtains or other combustible materials
could come into contact with it. In some
cases curtains may need restraining.
Other clearances are shown in the diagram.
THIS UNIT IS NOT DESIGNED TO
BE BUILT INTO BOOKCASE OR
SHELVES
Check that ventilation complies with local
regulations.
Check that an EARTHED power point
is within 1.5m of the right hand side of
the unit.
15Omm
150mm
Heater
10 -
150mm
,