Sanyo DC-X850 Instruction Manual page 10

BEFORE RECORDING AND DUBBING
~
"sedeckB
'Ore'02tape
Recording copyright material without permission of the copy-
right owners is usually an infringement. If you wish to re-record
copyright material permission from the copyright owner is nec-
Set the DOLBY NR button to ON or OFF as desired.
essary. SANYO does not approve of, and cannot be held re-
sponsible for, any unlawful use of this machine.
Accidental erasure prevention tabs (for protecting
valuable recordings)
Accidental erasure can be prevented by breaking out the tabs on the end
of the cassette tape (where the tape is not exposed) using a screwdriver
>* T?!!!$I
or similar implement.
Side B
-'~1 I /
If a tab is broken out in error and you wish to re-record the tape, simply
v '---
[
w
J
block the tab hole using adhesive tape and the tape can be used for
Break out tab A for side A.
recording again.
Break out tab B for side B.
RECORDING
1.
2.
3.
4.
Play a compact disc, record, video cassette, video disc or tune in the
radio station to be recorded.
Load the cassette for recording.
Press the button to start recording. The button IS engaged
simultaneously.
For recording compact discs, refer to "CD synchronous record-
ing".
Press the WA button to stop recording.
When the end of the tape has been reached, automatic stop will be
CD synchronous recording
1.
Press the CD function button.
2. Load the disc and cassette.
3. Press the button.
After a few seconds, CD recording starts from the first track.
If the track has been selected before pressing the button,
recording starts from the selected track.
If the disc is playing before pressing the button, recording starts
from the beainnina of current track.
activated.
4. Press the WA ~utton-to stop recording. The CD player enters the
When beat interference is heard
pause mode.
5. Press the button again. Recording re-starts at that point.
A high-pitched noise called "beat" is sometimes heard during the record-
When the end of the tape has been reached, automatic stop will be
ing of radio broadcasts.
In cases like this, set the DUBB SPEED/BEAT CANCEL button to the
activated on the deck. The CD player will enter the pause mode.
When the last track has been played, disc play stops automatically.
position that reduces the level of the beat noise.
The deck will continue recording to the end of the tape.
For programmed recording, pfogramme the material in advance (as
described under "PROGRAMMED PLAY"). Press the MEMORY
button. While "TRACK and "MEMORY" are blinking, press the
button.
TAPE DUBBING
(DECK A to DECK B)
1. Load the playback cassette into deck A and a blank cassette into deck
B.
2. Press the TAPE function button.
3. Set the cassette in deck A to the point where recording will begin.
4. Select the dubbing speed with the DUBB SPEED/BEAT CANCEL
button.
NORMAL:
For dubbing while monitoring at normal speed.
HIGH:
For dubbing the tape at high speed (twice normal speed).
5. Press the II button of deck B.
6. Press the button of deck B.
7. Press the button of deck A to start dubbing.
8. To stop dubbing, press both dA buttons.
Automatic stop during dubbing
If deck B stops automatically, deck A continues playback mode at normal
speed.
If deck A stops automatically, deck B erases the tape to the end.
During dubbing, the DOLBY NR button has no effect on the copied
tape.
Do not change the dubbing speed during the dubbing operation.
-9-