Version Ka.15.10.0011; Version Ka.15.10.0012; Version Ka.15.10.0013; Version Ka.15.10.0014 - HP J9575A Manual

■ IGMP (CR_0000127974) - If a switch receives a PIM packet while it is in the querier election state, the switch gives
up the querier role and does not forward multicast traffic.

Version KA.15.10.0011

Status: Released and fully supported, but not posted on the web.
The following problem was resolved in software version KA.15.10.0011.
Uplink Failure Detection (CR_0000127868) - On a switch that is configured for uplink failure detection where
■
the link to monitor (LtM) or link to disable (LtD) is an LACP trunk, after reboot the link to monitor is listed as down
in the output of show uplink-failure-detection, and the link to disable is taken down by the switch.

Version KA.15.10.0012

Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0012.
Config (CR_0000127108) - After downgrading from a newer software version to a 15.10 software version, the output
■
of show run lists an incorrect software build version in the Created on release statement.
Config (CR_0000129797) - A config file that has the entry ipv6 ospf3 passive on a tunnel cannot be downloaded to
■
the switch.
■ GVRP (CR_0000129917) - When the switch receives its own GVRP frames, it learns from them instead of dropping
the frames.
GVRP (CR_0000130090) - After rebooting the switch, the configuration unknown-vlans disable does not work on
■
trunks.
Link (CR_0000128466) - After booting a switch with a port configured for 100-full, if that port is changed to 10-half
■
it will not link with a remote device that runs at 10-half.
QoS (CR_0000123663) - VRRP IPv4 DSCP is tagged as 0 and cannot be changed by remarking.
■

Version KA.15.10.0013

Status: Never released.
The following problems were resolved in software version KA.15.10.0013.
Crash (CR_0000126777) - With a combination of interface state changes along with IPV6 address configuration
■
changes, it is possible for the switch to reboot unexpectedly with a message similar to SubSystem 0 went down:
01/24/13 13:31:29, Invalid Instr HW Addr=0x000004a8 IP=0x4a8, Task='mIpCtrl' Task
ID=0xa9ca140 sp:0x470aab0 lr:0x723f4c, msr: 0x02029200 xer: 0x20000000 cr: 0x48000400.
■ Dynamic ARP Protection (CR_0000132073) - When a VLAN is configured for dynamic ARP protection and also
DHCP snooping, ARP packets should be forwarded but are incorrectly dropped when the arp-protect configuration
does not include the validate ip option.
■ Loop Protection (CR_0000127150) - Loop protection fails to detect a loop on a port configured for 802.1X
authentication, if 802.1X is not enabled globally.
■ PIM (CR_0000128681) - After a large number of multicast streams are added and old streams time out, the switch
might get into a state where it is unable to add new multicast streams, responding with a message similar to
IpAddrMgr: Failed to allocate new SW IP multicast group, table full FIB entry.

Version KA.15.10.0014

Status: Never released.
The following problems were resolved in software version KA.15.10.0014.
25