Pin Contact And Crimp Tools Part Numbers - Garmin G300 Installation Manual

Table 1-5. Pin Contact and Crimp Tools Part Numbers
LRU Contact Type
Socket, Mil
GDU 37X
Crimp, Size 20
GSU 73
GTP 59
011-00979-20
(Config
Pin, Mil Crimp,
module
Size 22D
w/EEPROM
kit)
011-00981-00
(thermocouple
kit)
Socket, Mil
GMU 44
Crimp, Size 20
011-00979-22
(Config Socket, Mil
module Crimp, Size 20,
w/Sockets & 26-30 AWG
Jackscrew kit)
1. Insertion/Extraction tools from ITT Cannon are all plastic; others are plastic with metal tip.
2. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
1.6.2 Cable Location Considerations
Use cable meeting the applicable aviation regulation for the interconnect wiring. Any cable meeting
specifications is acceptable for the installation. When routing cables, observe the following precautions:
•
All cable routing should be kept as short and as direct as possible.
•
Avoid sharp bends.
•
Avoid routing cables near power sources (e.g., 400 Hz generators, trim motors, etc.) or near
power for fluorescent lighting.
•
Analog Input wires routed too close to spark plugs, plug wires, or magnetos may result in erratic
readings.
Page 1-6
Revision A
Garmin
Recommended
Contact Part
Positioner
Number
M22520/2-08,
336-00094-00
Daniels K13-1
Positronic P/N
9502-4,
336-00021-00
ITT P/N
M22520/2-09,
Daniels P/N K42
M22520/2-08,
336-00022-00
Daniels K13-1
Positronic P/N
336-00022-01
9502-5
NOTES
Recommended
Insertion/
Extraction Tool
M81969/1-04
for size 22D
pins and
M81969/1-02
for size 20 pins
G300 Installation Manual –Installation Overview
Recommended
Hand Crimping
Tool
M22520/2-01
190-00921-01