Panasonic KX-TD816 Operating Instructions Manual page 51

1.5 During a Conversation
Call Transfer using a DSS button
Allows you to perform a Screened or Unscreened Call Transfer by using a DSS button.
There are 2 operations, depending on whether or not One-Touch Transfer* is set.
* One-Touch Transfer allows you to hold an outside call and transfer it to an extension by pressing one key. This
"With Transfer" mode
PT
During a conversation
• The other party is placed on hold and the destination extension
is called immediately.
"Without Transfer" mode
PT
During a conversation
! • If the destination extension does not answer the call within a pre-determined time (default:
!
• If there is no answer within 30 minutes after "Transfer Recall" starts, the line will be
• When the dialed extension is busy, you may access the extension by dialing "2" (Busy
PT • If you want to return to the held call, press the TRANSFER button or corresponding CO or
PT • A flexible CO button can be assigned as a DSS button.
PT • To use "One-Touch Transfer", System Programming is required.
• During a 5-party conference, you cannot transfer a call.
PT
SLT • If you want to return to the held call, flash the hookswitch before the destination extension
SLT • If "Hold-3" is assigned in System Programming, you must dial "20" after flashing the
• 1.2 Proprietary Telephone Settings, "Customizing the Buttons on Your Telephone",
• See the Installation Manual, Section 3, "Call Transfer – to Extension".
Technical Manuals Online! - http://www.tech-man.com
feature provides automatic hold and transfer, without pressing the TRANSFER button. System Programming is
required to use this function.
Press the flexible button
assigned as the DSS button.
TRANSFER
Press TRANSFER.
30 sec.), the call will return to you (Transfer Recall).
disconnected.
Station Signaling) or "3" (Executive Busy Override) and going on-hook.
INTERCOM button before the destination extension answers.
answers.
hookswitch.
DSS (Direct Station Selection) Button
Press the flexible button
assigned as the DSS button.
1-43
Operations