Carrier 38APS025-065 Installation Instructions Manual page 36

Table 11 — 38APD Low Sound Condenser Fan Electrical Data
SUPPLY
38APD
VOLTAGE
V-Ph-Hz
UNIT SIZE
Min
208/230-3-60 187
380-3-60 342
025
460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
027
460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
030 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
040 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
050 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
060
460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
070
460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
080 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
090 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
100 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
115 460-3-60 414
575-3-60 518
380/415-3-50 342
208/230-3-60 187
380-3-60 342
130
460-3-60 414
575-3-60 518
380/415-3-50 342
LEGEND
FLA — Full Load Amps
ICF — Maximum Instantaneous Current Flow
LRA — Locked Rotor Amps
MCA — Minimum Circuit Amps
MOCP— Maximum Overcurrent Protection
RLA — Rated Load Amps
NOTES:
1. Units are suitable for use on electrical systems where voltage
supplied to the unit terminals is not below or above the listed
minimum and maximum limits. Maximum allowable phase
imbalance is: voltage 2%; amps 10%.
2. All units/modules have single point primary power connection.
Main power must be supplied from a field-supplied disconnect.
3. For MCA that is less than or equal to 380 amps, 3 conductors
are required. For MCA between 381 and 760 amps, 6 conduc-
tors are required. Calculation of conductors required is based
on 75 C copper wire.
COMPRESSOR
CIRCUIT A
Max Qty RLA LRA Qty
254 48.1 245
418 23.7 145
506 1 18.6 125 1
632 14.7 100
440 18.6 118
254 51.3 300
418 26.9 139
506 1 23.1 150 1
632 19.9 109
440 23.1 140
254 55.8 340
418 34.0 196
506 1 26.9 179 1
632 23.7 132
440 26.9 174
254 35.8 239
418 23.7 145
506 2 17.9 125 2
632 14.3 80
440 17.9 118
254 48.1 245
418 23.7 145
506 2 18.6 125 2
632 14.7 100
440 18.6 118
254 51.3 300
418 26.9 139
506 2 23.1 150 2
632 19.9 109
440 23.1 140
254 55.8 340
418 34.0 196
506 2 26.9 179 3
632 23.7 132
440 26.9 174
254 55.8 340
418 34.0 196
506 2 26.9 179 3
632 23.7 132
440 26.9 174
254 51.3 300
418 26.9 139
506 3 23.1 150 3
632 19.9 109
440 23.1 140
254 55.8 340
418 34.0 196
506 3 26.9 179 3
632 23.7 132
440 26.9 174
254 55.8 340
418 34.0 196
506 3 26.9 179 3
632 23.7 132
440 26.9 140
254 55.8 340
418 34.0 196
506 3 26.9 179 3
632 23.7 132
440 26.9 174
CONDENSER FAN
CIRCUIT B
Total Qty FLA
RLA LRA
48.1 245 6.0
23.7 145 3.9
18.6 125 2 2.9
14.7 100 2.4
18.6 118 2.9
51.3 300 6.0
26.9 139 3.9
23.1 150 2 2.9
19.9 109 2.4
23.1 140 2.9
55.8 340 6.0
34.0 196 3.9
26.9 179 2 2.9
23.7 132 2.4
26.9 174 2.9
33.4 225 6.0
19.2 140 3.9
16.7 114 3 2.9
13.4 80 2.4
16.7 111 2.9
51.3 300 6.0
26.9 139 3.9
23.1 150 3 2.9
19.9 109 2.4
23.1 140 2.9
55.8 340 6.0
34.0 196 3.9
26.9 179 4 2.9
23.7 132 2.4
26.9 174 2.9
46.1 245 6.0
23.7 145 3.9
18.6 125 4 2.9
14.7 100 2.4
18.6 118 2.9
55.8 340 6.0
34.0 196 3.9
26.9 179 5 2.9
23.7 132 2.4
26.9 174 2.9
55.8 340 6.0
34.0 196 3.9
26.9 179 6 2.9
23.7 132 2.4
26.9 174 2.9
55.8 340 6.0
34.0 196 3.9
26.9 179 6 2.9
23.7 132 2.4
26.9 174 2.9
73.9 505 6.0
38.2 290 3.9
30.4 225 7 2.9
24.6 180 2.4
30.4 225 2.9
85.3 605 6.0
51.9 353 3.9
41.9 272 8 2.9
34.7 240 2.4
41.9 272 2.9
4. Wiring for main field supply must be rated 75 C. Use copper
conductors only.
a. Incoming wire size range for terminal block with MCA up to
175 amps is 14 AWG (American Wire Gage) to 2/0.
b. Incoming wire size range for terminal block with MCA from
175.1 amps to 420 amps is 2 AWG to 600 kcmil.
c. Incoming wire size range for non-fused disconnect with MCA
up to 100 amps is 14 AWG to 1/0.
d. Incoming wire size range for non-fused disconnect with MCA
from 100.1 amp to 200 amps is 6 AWG to 350 kcmil.
e. Incoming wire size range for non-fused disconnect with MCA
from 200.1 amp to 450 amps is 3/0 to 500 kcmil.
36
REC
MCA MOCP ICF
FUSE
120.2 150 150 305.1
61.1 80 70 176.5
47.7 60 60 149.4
37.9 50 45 119.5
47.7 60 60 142.4
127.4 175 150 363.3
68.3 90 80 173.7
57.8 80 70 178.9
49.6 60 60 133.7
57.8 80 70 168.9
137.6 175 175 407.8
84.3 110 100 237.8
66.3 90 80 211.7
58.1 80 70 160.5
66.3 90 80 206.7
165.4 200 175 359.6
103.5 125 110 218.9
82.4 100 90 185.0
66.1 80 70 128.2
82.4 100 90 178.0
229.6 250 250 465.5
119.6 125 125 225.0
97.9 110 110 219.0
81.4 100 90 165.5
97.9 110 110 212.0
252.2 300 300 522.4
145.9 175 175 299.4
118.3 125 125 263.7
102.7 125 110 205.1
118.3 125 125 253.7
293.9 300 300 564.1
163.2 175 175 316.7
127.9 150 150 273.3
107.0 125 125 209.4
127.9 150 150 268.3
323.0 350 350 587.2
198.0 225 225 347.6
155.7 175 175 298.2
136.4 150 150 236.4
155.7 175 175 293.2
371.3 400 400 641.5
214.6 225 225 368.1
174.1 200 200 319.5
151.1 175 150 253.5
174.1 200 200 309.5
384.8 400 400 655.0
235.9 250 250 389.4
185.5 200 200 330.9
162.5 175 175 264.9
185.5 200 200 325.9
449.6 500 500 862.2
253.5 300 250 495.7
199.8 225 225 386.8
167.9 175 175 317.1
199.8 225 225 386.8
492.6 500 500 991.0
301.9 350 350 590.0
240.1 250 250 459.7
203.1 225 225 399.7
240.1 250 250 459.7