To Enter User Maintenance Mode - Panasonic DBS 576HD User Manual

FF1
FF2
FF3
FF4
FF5
FF6
FF7
FF8
FF9
FF10
Once in a data entry level, you must either enter an acceptable value or restore the
previous value before proceeding. For instance, if you change an entry to an
unacceptable value and then press FF1 to move to the PSD Assignment menu, you
will not be able to proceed. You must first enter an acceptable value. See Section
700 - Feature Operations for additional information on Maintenance Mode.

To Enter User Maintenance Mode:

1. Press the ON/OFF key on a telephone with a COS that allows user login.
2. Press the PROG key.
3. Press the * key twice.
4. Press the CONF key.
Note: Your extension's Class of Service must be properly set to allow User
Maintenance access. Also, only one user may enter User Maintenance or System
Programming at a time.
Absence Messages
To create Absence Messages using either a large-display
or small-display phone:
1. Enter "User Maintenance" by pressing:
12 HOLD HOLD
2. Enter: and press
Message Number (0-9)
3. Enter:
Absence Message
4. Enter:
5. If using a large-display phone, press the soft key next to the desired row of
letters.
6. If using a small-display phone press the appropriate one-touch key.
Note: Press the FLASH key to clear any existing data.
576-36-750
2. Setting Up Your Phone
Moves to Personal Speed Dial (PSD)
Assignment menu
Moves to System Speed Dial (SSD) Assignment
menu
Moves to Extension Name menu
Moves to Verified ID Code menu
Moves to Call Forward ID Code menu
Moves to Message Key ID Code menu
Moves to System Mode menu
Moves to Walking /Station Lock TRS
Moves to TRF of CWRD
Moves to CID Logging Ext.
ON/OFF PROG * * CONF
.
.
(up to 15 characters):
DBS 576 (USA), issued October 2000 35