Configure Your Pc; Connect To Your Device Wirelessly - Tenda teg2124t User Manual

Step 5: Connect the other end of the Ethernet cable to a switch and plug the included power adapter into a
power outlet;
Step 6: Check the network topology as shown below:

2.2 Configure Your PC

The default IP address of your wireless access point is 192.168.0.254. If you are using the default IP subnet,
the computer you are using to connect to the device should be configured with an IP address that starts with
192.168.0.X (2~253) and a Subnet Mask of 255.255.255.0; if you have changed the subnet of the wireless
access point, the computer you are using to connect must be within the same subnet. If you are not clear
about this configuration, please refer to

2.3 Connect to Your Device Wirelessly

Having finished above settings, you can search for the device's default wireless network (SSID) from your
wireless devices (notebook, iPad, iPhone, etc) and enter a security key to connect to it wirelessly.
Tip --------------------------------------------------------------------------------------------------------------------------------------
1. The device's SSID is Tenda_XXXXXX by default and XXXXXX is the last six characters of the MAC
address which you can find on this device's label.
2. To join your wireless network, the PC you use must have an installed wireless network adapter. If not,
install one.
-----------------------------------------------------------------------------------------------------------------------------------------------
Appendix ---1. Configure PC TCP/IP Settings.
10
300M Wireless AP