Lamp Indicator - Epson EMP-7600 Owner's Manual

Indicator Status
Blinking in Green
Illuminated in Red
Extinguished

Lamp Indicator

Indicator Status
Blinking in Red
Blinking in Orange
Extinguished
70 - Troubleshooting
Cause
Warm-up in
progress
Internal error
The power is not
switched on
Cause
Lamp error
Time to replace the
lamp.
Recovery or Status
(Not an error)
· Wait for a moment.
· The green lamp will stop blinking and
become illuminated once the warm-up
procedure has been completed.
Cease operations, remove the Power Plug from
the socket and contact your dealer or nearest
address provided at "International Warranty
Conditions" in "Safety Instructions/World-
Wide Warranty Terms" included in the pack-
age and request repairs.
The power is not switched on.
· Check the power cord connection.
· Check the power supply to the socket.
Recovery and Status
· Replace with a new lamp (ELPLP12).
· If the lamp is broken, take care to avoid injury
and contact your nearest address provided at
"International Warranty Conditions" in
"Safety Instructions/World-Wide Warranty
Terms" included in the package to request
repairs.
· Ensure that the lamp and lamp cover have
been attached firmly after replacing the lamp.
The equipment is fitted with a mechanism
that prevents the lamp from being switched
on if the lamp and lamp cover are not
securely in place.
Replace with a new lamp (ELPLP12).
(Not an error)
The power has not been switched on or nor-
mal projection is in progress.
Reference
Page
37
37
Reference
Page
83
83