Table of Contents
Advertisement
EN 42
– put 26 mm blocks (1) under the front
edge of the deck and 32 mm blocks (2)
under the rear edge, and thenput the lif-
ting lever into position «1»;
– completely loosen the adjuster (3), the
nuts (4 - 6 - 8) and the locknuts (5 - 7 -
9) of the three trace rods until the deck is
resting on the blocks;
– turn the two right-hand upper nuts (6 - 8)
and the left-hand lower nut (4) to the
point where the deck just begins to lift.
Tighten the three locknuts (5 - 7 - 9) and
turn the adjuster (3) until the control
cable is taut.
Any difference in height from the ground
between the left and right sides of the deck
can be compensated by turning the two
nuts (4 - 8) and locknuts (5 - 9) of just the
back rods.
Put the control lever in 2 or 3 different posi-
tions and check that the deck rises evenly
and that at each position it constantly main-
tains the difference in height from the
ground between the front and back edges.
If the front part tends to rise faster or slower it can be adjusted by turning the nuts
(10) on the link rod (11).
Turning the nuts clockwise will lift the front part and make it rise faster, and tur-
ning anti-clockwise will give the opposite effect.
Remember to tighten all the nuts and locknuts once these adjustments have been
made.
If you are unable to get the cutting deck adjusted properly, consult your Dealer.
1 - h = 26 mm
8
9
5
4
11
6
7
MAINTENANCE
2 - h = 32 mm
3
10
Advertisement
Table of Contents
