Honda CG71505014H Owner's Manual page 47

TROUBLESHOOTING
PROBLEM
6. Weak engine
performance during
cutting
7. Engine stops and
the pilot lamp flashes
8. Engine stops and
the pilot lamp goes out
9. The engine stops
and the pilot lamp
remains on
10. The blades do not
engage
11. Uneven cut and
poor grass collection
LIKELY CAUSE
– forward speed too high in relation to
cutting height (☛ 5.4.5)
– intervention of the safety devices (☛
5.2)
The protection of the electronic card has
cut in due to:
– earthed micro-switch
– battery contains electrolyte but is not
charged
– overvoltage caused by the charge
regulator
– badly connected battery (poor contact)
– engine badly earthed
– problems in the engine
– cable lengthened or belt loosened
– cutting deck not parallel to the ground
– blade cutting badly
– forward speed too high compared to
height of grass (☛ 5.4.5)
– collector channel is blocked
– cutting deck full of grass
SOLUTION
– reduce the forward speed and/or raise
the cutting deck
– Check that the conditions are met (☛
5.2)
Turn the key to «STOP» and look for the
cause of the problem:
– check connections
– recharge battery (☛ 6.2.5)
– contact your Dealer
– check connections i (☛ 3.4)
– check engine earth connection
– contact your Dealer
– turn the adjusting nut (☛ 6.3.3)
– check the tyre pressures (☛ 5.3.2)
– re-align the cutting deck to the ground
(☛ 6.3.2)
– check that the blades are fitted pro-
perly (☛ 6.3.1)
– sharpen or fit new blades (☛ 6.3.1)
– check the tension of the belt and con-
trol cable of the blade engagement
lever (☛ 6.3.3)
– reduce forward speed and/or raise the
cutting deck
– wait for the grass to dry
– remove the grass-catcher and empty
the collector channel (☛ 5.4.7)
– clean the cutting deck(☛ 5.4.10)
EN 47