Table of Contents
Advertisement
HOW TO USE THE MACHINE
– start moving forwards onto the grass area very gradually and with particular
caution, as already described;
– adjust the forward speed and the cutting height (☛ 4.8) according to the lawn
condition (height, density and dampness of the grass). On flat ground, these
general conditions can be followed
High and dense grass - wet lawn
Average condition grass
Low grass - dry lawn
➤
For hydrostatic drive models:
The speed is controlled in a gradual and progressive way by the pressure on
the drive pedal.
WARNING!
!
must be reduced to ensure safe conditions ( ☛ 1.2 - 5.5).
In any case, the speed should always be lowered if you note a reduction in engi-
ne speed, since a forward speed that is too fast compared to the amount of grass
being cut will never mow the grass well.
Disengage the blades and put the cutting deck in the highest position whenever
you need to get past an obstacle.
5.4.6 E
MPTYING THE GRASS
NOTE
otherwise the engine stops.
Do not let the grass-catcher become too full as this may block the collector chan-
nel.
When the grass-catcher is full there is an audible warning. At this point:
– lower the engine speed;
– go into neutral (N) (☛ 4.22 -mechanical model- or 4.32 -hydrostatic model-)
and stop forward movement;
– engage the parking brake on slopes;
When cutting on sloping ground, the forward speed
-
CATCHER
This operation can only be done with the blades disengaged,
2 km/h
3,5 ... 5.5 km/h
over 5.5 km/h
EN 27
Advertisement
Table of Contents
