How To Change The Position Of The Connector Panel - Panasonic AW-RP555N Operating Instructions Manual

How to change the position of the connector panel

The position of the connector panel can be changed from
the rear panel to the bottom panel.
 Before changing the position, turn off the power.
 Remove the four bottom panel screws, and remove the
blank panel.
 Remove the four rear panel screws, and remove the
connector panel.
 Secure the blank panel to the rear panel using the screws.
 Remove the two rubber feet from the blank panel.
 Secure the connector panel to the bottom panel using the
screws.
Remove the blank panel.
Remove the connector panel.
TALLY5
TALLY3
TALLY1
TALLY2
TALLY4
TALLY GND
TALLY IN
R S
REMOTE/SERVICE
Blank panel
Connector panel
TALLY5
TALLY3
TALLY1
TALLY2
TALLY4
TALLY GND
TALLY IN
R S
REMOTE/SERVICE
27
Screws × 4 (bottom panel)
Screws × 4 (rear panel)
DC12V IN
GND
TO PAN/TILT HEAD
MONITOR SELECT
5 4 3 2 1/EXT
Screws × 4 (rear panel)
Remove the two rubber feet.
Screws × 4 (bottom panel)
DC12V IN
GND
TO PAN/TILT HEAD
MONITOR SELECT
5 4 3 2 1/EXT