Panasonic AW-RP555N Operating Instructions Manual page 6

Parts and their functions
 SHUTTER button
This is used to select the shutter speed of the camera in
the pan/tilt head system currently selected.
Each time the button is pressed, the set shutter speed is
switched to shutter OFF or vice versa.
The shutter speed is actually switched as soon as the
button is released.
At any setting except OFF, the button's lamp lights; at the
OFF setting, it is off.
[How to register the shutter speed]
1. Press the SHUTTER button while holding down the
MEMORY button.
2. The PRESET [1 to 5] buttons and PRESET [6 to 10]
buttons start flashing alternately.
3. Press the PRESET button that corresponds to the
shutter speed to be registered.
The table below lists the shutter speeds which can be
set.
1/100 PRESET 1
1/250 PRESET 2
1/500 PRESET 3
1/1000 PRESET 4
1/2000 PRESET 5
 When OFF is set, the shutter will not be operated
even when the SHUTTER button is pressed.
Select the SYNCRO-SCAN setting from the camera
menu.
The change in the shutter speed is reflected when
the shutter is next set to ON.
This setting is retained in the memory even after the
control panel's power has been turned off.
[When temporarily changing the shutter speed without
registering it]
Press the PRESET button corresponding to the shutter
speed to be set while holding down the SHUTTER button.
Refer to the table above for the shutter speeds which can
be set.
The shutter speed will be changed as soon as the
PRESET button is pressed.
This setting will be cleared when either the shutter button
is pressed or the camera's power is turned off.
AUTO
GAIN
MANU
OPERATE
0dB
L
MODE H
ON CAM
BAR
CONT
CAM
SHUTTER
ON
OFF
OFF
TALLY
2 3 4 5
CONTROL
1 2 3 4 5
IRIS
LEVEL
MEMORY
AUTO
MANU
SPEED ZOOM
LOW TELE
HIGH
WIDE
1/4000 PRESET 6
1/10000 PRESET 7
SYNCRO-SCAN PRESET 8
ELC PRESET 9
OFF PRESET 10
Multi Hybrid Control Panel AW-RP555
WHT BAL SCENE FILE
AWC
A
USER
B 1
NG
OK
MENU
ABC 2
MENU ITEM YES NO
ATW
3
PRESET
DEF WIP H/F
1 2 3 4 5
(AF)
EXT ND OP
6 7 8 9 10
LAMP
FOCUS PAN/TILT
FAR
UP
LEFT RIGHT
DOWN
NEAR
 WHITE BAL [A/B/ATW] buttons
These are used to select the camera's white balance
adjustment in the pan/tilt head system currently selected.
A: When the A button is pressed, the white balance
status entered in the camera's memory A is
established, and the A button's lamp comes on.
If the AWC button is pressed after the A button
was pressed, the white balance is automatically
adjusted and entered in the camera's memory A.
B: When the B button is pressed, the white balance
status entered in the camera's memory B is
established, and the B button's lamp comes on.
If the AWC button is pressed after the B button
was pressed, the white balance is automatically
adjusted and entered in the camera's memory B.
ATW: When the ATW button is pressed, the white
balance is set to the automatic adjustment
mode, and the ATW button's lamp comes on.
6