Genlock Adjustment; Total Pedestal Adjustment - Panasonic AW-RP555N Operating Instructions Manual

Operation
4. Set the left end position in the travel range.
 Operate the PAN/TILT lever to rotate the camera to
the position which is to serve as the left end position.
 Press the PRESET 1 and 6 buttons while holding
down the MEMORY button.
 When the button 5 lamp lights, the setting is
completed.
 To cancel the setting, press the PRESET 1 and 6
buttons again while holding down the MEMORY
button. When the setting is canceled, the button 10
lamp lights.
5. Set the right end position in the travel range.
 Operate the PAN/TILT lever to rotate the camera to
the position which is to serve as the right end position.
 Press the PRESET 4 and 9 buttons while holding
down the MEMORY button.
 When the button 5 lamp lights, the setting is
completed.
 To cancel the setting, press the PRESET 4 and 9
buttons again while holding down the MEMORY
button. When the setting is canceled, the button 10
lamp lights.
6. Use the CONTROL button to switch the pan/tilt head
system. and set the travel ranges (limiters) for each
system concerned.
WHT BAL
AUTO
GAIN
A
OPERATE MANU
0dB
L
MODE H
B
CAM
ON
BAR
CONT
CAM
SHUTTER
ATW
ON
OFF
OFF
TALLY
2 3 4 5
1
CONTROL
1 2 3 4 5
6
IRIS
LEVEL
MEMORY
AUTO
MANU
SPEED ZOOM
LOW TELE
HIGH
WIDE
Multi Hybrid Control Panel AW-RP555
SCENE FILE
AWC
USER
1
NG
OK
MENU
2
ABC
MENU ITEM YES NO
3
PRESET
DEF WIP H/F
2 3 4 5
(AF)
EXT ND OP
7 8 9 10
LAMP
FOCUS PAN/TILT
FAR
UP
LEFT RIGHT
DOWN
NEAR
Genlock adjustment
If a camera is to be synchronized with an external signal for
use, genlock adjustment must be performed for the camera
and other equipments.
Either the black burst or VBS (video, burst and sync) signal
is used for the external sync signal.
There is no need to perform the genlock adjustment if the
camera is not going to be synchronized with an external
signal.
For the genlock adjustments, open the camera menu and
perform the settings. Refer to the instructions accompanying
the camera and cable compensator.
Total pedestal adjustment
When more than one camera is to be used, the black level
(pedestal level) of the pictures shot by each of the cameras
must be brought into alignment.
Set the black level (pedestal level) using the camera menu.
For details, refer to the instructions accompanying the
camera.
21