Advertisement
Mounting of Filament Spool
① Prepare the filament spool to be used.
Cut off the filament sticking out of the
filament fixing hole at the center of the
spool and remove the fixing tape of the
filament.
②
Push the spool door handle on the printer body in
the direction of the arrow shown in the picture to open
the door of the spool carrier.
④
Open the top door and push the filament all the way
into the printer body so that the filament is out of the
Teflon tube.
Be careful not to bend, cut or twist the filament
tube.
This may prevent the filament from being supplied
properly.
Confirm that the packaging materials inside the printer have been completely removed, that
there is no damage, and that the spool mounting/rotation direction/rotation conditions are all
normal before turning on the printer.
Copyright Reserved HyVISION System Inc.
This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for
product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Unpacking and Installation (3/4)
Cutting
③
Slowly unwind the filament from the filament spool
and insert the filament into the filament insertion hole.
* Be careful of the spool rotation/insertion
direction.
⑤
Insert the filament spool into the filament rod and
push the handle until you hear a clicking sound. Close
the spool door and fix the spool.
* Be careful of the spool rotation/insertion direction
1
2
Spool
Rotation
8
Advertisement
