Advertisement
⑤ After loading, navigate to the {SD Card} menu by
pressing the 【BACK】 button.
Insert the supplied SD card into the SD memory
insertion hole and select the file to be output. You can
select a file from the G-Code (*.hvs) file list in the SD
card.
Select the "ABS_*.hvs" file if the mounted filament
is ABS and the "PLA_*.hvs" file if the mounted
filament is PLA.
Only the files with the extension *.hvs can be used for
printing. Files in other formats will not be printed.
⑥ Raise the heating bed temperature and extruder
temperature sequentially to the temperature conditions
recorded in the G-Code file, and run auto tilt of heating
bed in auto to begin printing.
This document has described how to install the printer and print a sample.
Please carefully read the latest operation manual included in the SD card or downloaded from
Cubicon homepage (www.3dcubicon.com) before using the printer.
Thank you again for purchasing Cubicon Single!
Copyright Reserved HyVISION System Inc.
This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for
product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Initial Printing (2/2)
⑦
When printing is completed, do not try to
forcibly separate the molded object, but wait until
the heating bed is cooled. The molded object can
be easily separated from the heating bed when the
temperature of the heading bed decreases to room
temperature.
If the molded part is not easily separated from the
heating bed even when the heating bed is cooled, it
will help if you make a space at the edge of the bottom
of the molded part with a flat object.
12
Advertisement
