Advertisement
This section describes the printing of an actual sample using the sample slicing file (G-code file) in the
supplied SD memory card after the printer is installed.
Before you print the sample, you are recommended to carefully read the latest operation manual
inside the SD card, or downloaded from Cubicon homepage (www.3dcubicon.com).
① Mount the filament spool to the spool carrier of the
printer and insert the filament all the way into the
Teflon tube inside the printer.
③
Press
"Check
Filament".
Filament" is displayed, and the following
messages are displayed in sequence.
Set the temperature to 240℃.
During the loading process, filament with a different color from the mounted filament may
appear. This is residue from factory testing, and is normal.
Copyright Reserved HyVISION System Inc.
This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for
product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
② Turn on the printer. Since there is no filament in the
extruder initially, "No Filament" is displayed.
Press the 【ENTER】 button to initiate the function
menu. "Check Filament" flickers.
④ Press the 【BACK】 button and select "Load filament". The
"Unload
following messages are displayed in sequence.
temperature to 240℃.
Initial Printing (1/2)
Set the
11
Advertisement
