Advertisement
⑦ Remove the package and tape. Set the horizontal levelness of the printer by adjusting the feet, while referring
to the inclinometer.
* The driving part is fixed with packaging material only, without using a cable tie, in order to
prevent potential problems when the printer is operated. Please be careful not to damage
the part when removing the internal packaging material.
* The extruder-driven cable and the Teflon tube are located near the extruder fixing
packaging material. Since the extruder-connected cable and Teflon tube are the moving
path of the filament, they should be handled carefully to avoid damage from being
excessively pulled, bent or pressed.
Mounting of Clean Filter
① Pull out the clean filter case from the printer body.
③ Insert the clean filter case into the printer body.
Mount the clean filter in the correct position inside the case. If it is positioned incorrectly, the
filter performance will degrade and cause a malfunction of the ventilation fan.
Copyright Reserved HyVISION System Inc.
This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for
product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Unpacking and Installation (2/4)
Inclinometer
② Place the clean filter inside the case.
Position the clean filter carefully.
7
Advertisement
