Advertisement
Tweezers (x1)
Used
substances, such as filament
residues
Scrapper (x1)
Used to separate the molded part
or remove foreign substances
from the heating bed
Antistatic brush (x1)
Used to remove the pollutants
such as the filament residues.
Nozzle pin ф=1.5mm (x1)
Used to clean inside of the nozzle
when
deteriorated due to a polluted
nozzle.
SD Memory (x1)
Stores the slice files of 3D models
for molding used by the printer
* The filament spool and clean filter are not mounted in the printer, but are packaged separately.
* The type and specification of the accessories included in the part may be changed without
notice to enhance the product.
* Please use the Cubicon homepage or contact a distributor to purchase additional accessories.
Using an unauthorized filament or part may cause damage to the product. Any problem related
to the use of an unauthorized part will not be covered by the after-sales service. Always use
accessories supplied by Cubicon.
Copyright Reserved HyVISION System Inc.
This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for
product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Accessories Included with Package
to
remove
foreign
the
output
quality has
Power cable (x1)
The power cable for the printer
USB cable Type-A/Type-B (x1)
Connected to a PC and used for
output printing
Clean filter (x1)
Mounted in the clean filter case of
the main body
Filament spool (x2)
Mounted in the spool carrier. A
filament spool is provided to both
PLA and ABS (random color).
Quick Start Guide /
Operation
Operation Manual
Manual
Included as a printout or a file in
the SD memory
5
Advertisement
