Advertisement
Thank you for purchasing Cubicon Single!
Please read this 'Safety Caution' before using the printer and always follow the guideline provided.
This guideline is provided to ensure the safety of users, prevent the injury of third parties and prevent
damage to the printer.
Failure to follow this guideline may lead to serious injuries or printer damage.
Since the printer generates a high level of heat during operation, there is the risk of burning if you place
your finger or another part of your body or fixtures inside the printer during operation. Place the body part
or fixtures only after the operation is terminated and the printer has been sufficiently cooled.
The printer has a number of moving parts, including the motor, belt and gear. There is the risk of injury or
property damage from being trapped if a body part or fixtures are placed inside the printer during an
operation.
Penetration of water or other liquids as well as the metal pieces or other conductive foreign substances
inside the printer can cause fire or electric shock. Please take care to avoid operating the printer with wet
hands, as this can cause fire or electric shock.
Select the installation site carefully to avoid causing injury to children or pets. Children or pets must be
observed and protected carefully if they are near the printer.
The printer and its parts have sharp edges. Be careful to avoid injury or printer damage.
Since the filament used in the printer can cause fire or injury, do not heat it or deform it with another piece
of equipment. Carefully handle the outputs and filament scraps, as swallowing them can cause suffocation,
etc.
Never use a volatile substance with the printer, as it can cause a fire or explosion. In addition, remove
ignition materials or flammable materials around the printer as they can cause fire.
The printer uses a high brightness LED for illumination. Do not look at it directly in order to protect your
eyes.
Do not destroy or alter the printer's power cable or USB cable, and make sure that only the rated voltage is
supplied.
To move the printer, stop the printer operation and disconnect the power cable and USB cable after the
internal parts are sufficiently cooled and the printer is turned off.
Do not place a filament or object in an empty space inside the printer, as it can cause printer damage and
fire.
As the printer uses a melted material that may generate an odor, install the printer in a well-ventilated area.
Do not install the printer outdoors or in a vibrating, humid or dusty area.
Do not install the printer in an unstable or uneven surface.
In addition, please take care to remove any object that may be damaged by the heat or vibration generated
by the printer's operation.
If an unauthorized filament or part is used with the printer, it may damage the product and/or violate the
conditions of the product warranty. Any problem caused as a result will not be covered by the warranty.
Do not disassemble or alter the printer except as specified in the Operation Manual, as it may cause the
injury or printer damage. Any problem caused as a result will not be covered by the warranty.
Do not apply excessive force or impact to the printer, as it may cause injury or printer damage. Read the
caution in the Operation Manual carefully before using the printer.
Copyright Reserved HyVISION System Inc.
This document is the Quick Start Guide (141020,kr), and is subject to change without notice when necessary for
product improvements. HyVISION System does not take the responsibility for loss caused by any error in the
document or provisions and use of this document.
Safety Caution
2
Advertisement
