Terminal Emulator Display Settings; Terminal Emulator Connection Settings - HP MSA 2040 User Manual

3. Enable the CLI port for subsequent communication:
• Linux customers should enter the command syntax provided in
cabling to the CLI port" (page
• Windows customers should locate the downloaded device driver described in
device driver for Windows computers" (page
installation.
4. Start and configure a terminal emulator, such as HyperTerminal or VT- 1 00, using the display settings in
Table 2 and the connection settings in
Table 2 Terminal emulator display settings
.
Parameter
Terminal emulation mode
Font
Translations
Columns
Table 3 Terminal emulator connection settings
Parameter
Connector
Baud rate
Data bits
Parity
Stop bits
Flow control
1
Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2
Verify the appropriate COM port for use with the CLI.
5. In the terminal emulator, connect to controller A.
6. Press Enter to display the CLI prompt (#).
The CLI displays the system version, MC version, and login prompt:
a. At the login prompt, enter the default user manage.
b. Enter the default password !manage.
If the default user or password—or both—have been changed for security reasons, enter the secure
login credentials instead of the defaults shown above.
NOTE: The following CLI commands enable you to set the management mode to v3 or v2:
• Use
set protocols
• Use
set cli-parameters
The system defaults to v3 for new customers and v2 for existing users (see the CLI Reference Guide
for more information).
7. At the prompt, type the following command to set the values you obtained in
port, first for controller A and then for controller B:
45).
45), and follow the instructions provided for proper
Table 3 (also, see the note following this procedure).
Value
VT- 1 00 or ANSI (for color support)
Terminal
None
80
Value
1,2
COM3 (for example)
1 15,200
8
None
1
None
to change the default management mode.
to change the current management mode for the CLI session.
"Preparing a Linux computer before
"Downloading a
step 1 for each network
Obtaining IP values 47