Disk Drive Leds - HP MSA 2040 User Manual

Disk drive LEDs

2.5" SFF disk drive
(sled grate is not shown)
Online/Activity (green)
On
Blinking irregularly
Off
On
Blinking irregularly
Off
Off
On or blinking
Blinking regularly (1 Hz)
Off
1
This Fault/UID state can indicate that the disk is a leftover. The fault may involve metadata on the disk rather than the disk itself.
See the Clearing disk metadata topic in the SMU Reference Guide or online help.
Figure 33 LEDs: Disk drive combinations — enclosure front panel
IMPORTANT:
and the SMU Reference Guide or online help.
2 1
Fault/UID (amber/blue)
Off
Off
Amber; blinking regularly
(1 Hz)
Amber; blinking regularly
(1 Hz)
Amber; blinking regularly
(1 Hz)
1
Amber; solid
Blue; solid
Blue; solid
Off
Off
For information about self-encrypting disk (SED) drives, see
2 1
1
2
Description
Normal operation. The disk drive is online, but it is not
currently active.
The disk drive is active and operating normally.
Offline: the disk is not being accessed. A predictive failure
alert may have been received for this device. Further
investigation is required.
Online: possible I/O activity. A predictive failure alert may
have been received for this device. Further investigation is
required.
The disk drive is active, but a predictive failure alert may
have been received for this disk. Further investigation is
required.
Offline: no activity. A failure or critical fault condition has
been identified for this disk.
Offline: the disk drive has been selected by a
management application such as the SMU.
The controller is driving I/O to the disk, and it has been
selected by a management application such as the SMU.
CAUTION: Do not remove the disk drive.
Removing a disk may terminate the current
operation and cause data loss. The disk is
reconstructing.
Either there is no power, the drive is offline, or the drive is
not configured.
"FDE considerations" (page 19)
3.5" LFF disk drive
Disk drive LED key:
= Fault/UID (amber/blue)
= Online/Activity (green)
Front panel LEDs 81