Msa 2040 6 Gb 3.5" 12-Drive Enclosure-Rear Panel Layout; D2700 6Gb Drive Enclosure - HP MSA 2040 User Manual

NOTE: See "Powering on/powering off" (page 28)
MSA 2040 6 Gb 3.5" 12-drive enclosure—rear panel layout
MSA 2040 controllers support the MSA 2040 6 Gb 3.5" 12-drive enclosure. The front panel of the drive
enclosure looks identical to that of an MSA 2040 Array LFF. The rear panel of the drive enclosure is shown
below.
LED Description
1 Power supply LEDs
2 Unit Locator
3 OK to Remove
4 Fault/Service Required
5 FRU OK
6 SAS In Port Status
7 SAS Out Port Status
Figure 39 LEDs: MSA 2040 6 Gb 3.5" 12-drive enclosure rear panel
The MSA 2040 6 Gb 3.5" 12-drive enclosure is identical in outward physical appearance to the legacy
P2000 G3 6 Gb 3.5" 12-drive enclosure. For information about upgrading P2000 G3 components for use
with MSA 2040 controllers, see

D2700 6Gb drive enclosure

MSA 2040 SAN controllers support D2700 6Gb drive enclosures. For information about the D2700, visit
http://www.hp.com/support. Pictorial representations of this drive enclosure are also provided in the MSA
2040 Quick Start Instructions and MSA 2040 Cable Configuration Guide.
for information on power-cycling enclosures.
1 2
IN
IN
3 4 5
Definition
See "Power supply LEDs" (page
Off — Normal operation.
Blinking white— Physically identifies the expansion module.
Not implemented.
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled powerup or a cache flush
or restore error.
Green — Expansion module is operating normally.
Blinking green — System is booting.
Off — Expansion module is not OK.
Green — Port link is up and connected.
Off — Port is empty or link is down.
Green — Port link is up and connected.
Off — Port is empty or link is down.
"Upgrading to MSA 2040" (page
0 0
OUT
0 0
OUT
6 7
86).
18).
1
Rear panel LEDs 87