Maintenance & Lubrication Charts; General; Maintenance Chart - Jacobsen Tournament Cut 22 Technical Manual

9 MAINTENANCE & LUBRICATION CHARTS
9 MAINTENANCE & LUBRICATION CHARTS
9.1

GENERAL________________________________________________________________

Over greasing will produce high loads on the bearings
and engine; thereby reducing the performance of the
machine.
All maintenance intervals must be performed more
frequently when operating in extremely dusty conditions.
!
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine and disconnect spark
plug wire to prevent injuries.
9.2

MAINTENANCE CHART ____________________________________________________

Air Cleaner
Combustion Chamber
Engine Oil
Fuel Line
Fuel Strainer
Spark Plug
Valve Clearance
Grease Locations
L1 - L7
L8 - L11
L12
Gear Cases
A - Add or Adjust
* Indicates initial service for new machines.
Engine Oil - See Section 7.3
I
Excelite EP No 2 Grease, Jacobsen Part No. 4127663 (400 gram tube)
II
III Dynamax No. 1 Grease, Jacobsen Part No. 4127662 (400 gram tube)
GB-24
WARNING
Every
8-10
Hours
I
I
L
C - Clean
1. Always clean grease fittings before and after lubrica-
tion.
2. Apply grease with a manual grease gun and fill
slowly until grease begins to seep out. Do not use
compressed air.
3. For smooth operation of pivot points and other
friction points, apply several drops of SAE 30 oil
every 50 hours or as required.
4. To lubricate fitting L12, remove engine clutch cover.
Recommended Service and Lubrication Intervals
Every Every Every
20 50 100
Hours Hours Hours
C
R* R
C
A/R
L
I - Inspect L- Lubricate
Every Yearly Lubricant
250 Type
Hours
R
C
I
R - 2yrs
A
II
II
L
II
AR
III
R - Replace AR - As Required