Operation Daily Inspection; Operator Presence Control (O; Operation 5.1 Daily Inspection - Jacobsen Tournament Cut 22 Technical Manual

5 OPERATION
5.1 DAILY INSPECTION ________________________________________________________
!
The daily inspection should be performed only when
the engine is off and all fluids are cold. Disengage all
drives, engage parking brake, stop engine and
disconnect spark plug wire.
1. Perform a visual inspection of the entire unit, look for
signs of wear, loose hardware, missing or damaged
components. Check for fuel or oil leaks.
5.2 OPERATOR PRESENCE CONTROL (O.P.C.) ____________________________________
1. The O.P.C. system is intended to protect the opera-
tor and others from injury by stopping the reel and
drive mechanism as soon as the operator releases
the O.P.C. bail.
!
Never operate equipment with the O.P.C. system
disconnected or
disconnect or bypass any switch.
2. To test the system, the mower must have the
transport wheels attached.
a. Place mower on the kickstand.
b. Disengage the reel clutch lever (K
c. Engage the traction clutch lever (J
3. Start the engine and place throttle (B) at mid-point.
a. Engage O.P.C. bail (C) then push control lever
(A) to Drive position.
b. The drive mechanism will engage and the
wheels will begin to turn.
c. Release the O.P.C. bail. The bail must come up
and the wheels must stop.
4. If the wheels begin to turn before the O.P.C. bail is
engaged or the wheels continue to turn after the
O.P.C. bail is released; stop the engine immediately
and have the system repaired.
CAUTION
WARNING
malfunctioning. Do
).
2
).
1
2. Check the fuel supply and crankcase oil level. All
fluids must be at the full mark.
3. Make sure the mower is adjusted to the required
cutting height.
4. Make sure the machine is lubricated and the
transport tires are properly inflated.
5. Check the O.P.C. system.
J
1
not J
2
A
OPERATION
H
2
H
1
K
2
K
B
C
P
N
D
5
1
Figure 5A
Figure 5B
GB-11