Brake; Cutting Height; Handle - Jacobsen Tournament Cut 22 Technical Manual

6.6

BRAKE __________________________________________________________________

1. Place control lever (J) in neutal position.
2. Adjust nuts (H) as required to remove all slack from
brake cables.
6.7

CUTTING HEIGHT _________________________________________________________

Note: Make sure the bedknife is properly adjusted before
setting the cutting height. (See Section 6.4)
1. Push kickstand down and tip mower back on it's han-
dle. Do not leave the mower tipped back for an
extended length of time or oil may migrate into the
combustion chamber.
2. Loosen nuts (M) on both sides just enough to allow
knob (L) to raise the front roller or Turf Groomer.
Raise both sides an equal amount.
3. Set gauge screw (P) to the desired cutting height
(O). Measure from the gauge bar (N) to the
underside of the screw head (P) then tighten wing
nut to lock the adjustment.
4. Place gauge bar between front roller and traction
roller, near the outer end of the rollers.
5. Slide screw head over bedknife (Q) and adjust knob
(L) so roller just contacts the gauge bar. Tighten nut
(M).
6.8

HANDLE _________________________________________________________________

1. To adjust the angle of the handle bar (Y), loosen
screw (W) on both sides of the mower and adjust the
handle bar to the desired position.
2. After adjusting handle bar, adjust bracket (X) so that
the handle bar just rests on the bottom of the slot in
bracket. Tighten screw (W).
J
6. Repeat Steps 4 and 5 on the opposite end of the
reel then tighten nuts (M). Recheck and readjust the
cutting height if necessary.
L
M
N
O
ADJUSTMENTS
H
H
Figure 6E
Q
P
Figure 6F
Y
X
W
Figure 6G
6
GB-17