Yamaha RX-V4600 Owner's Manual page 60

SYSTEM OPTIONS
■ Rename (Rename)
Use this feature to change the name of the inputs in the
GUI or the front panel display menu. (DVD is used as the
source component in the following example.)
Input Select > input source (DVD, etc.) > Rename >
1
Press an input selector button to select the
input you want to change the name of.
2
Press l / h to place the _ (under-bar) under
the space or character you want to edit.
Decoder Mode
Volume Trim
Rename
3
Press ENTER to select a character type
(CAPITAL/SMALL/FIGURE/MARK).
4
Press k / n to select the character you want
to use and l / h to move to the next one.
• You can use up to 8 characters for each input.
• Press n to change the character in the following
order, or press k to go in the reverse order. Press
ENTER to switch between character types:
CAPITAL A to Z, space
SMALL a to z, space
FIGURE 0 to 9, space
MARK !, #, %, &, etc.
• Repeat steps 1 to 3 to rename each input.
5
Press l / h to select OK and press ENTER
when complete.
y
• To change source names in the display window on the remote
control, see page 76.
• This menu item is also available in the changing source names
in the display window feature (see page 76), and in the front
panel display system options menu (see page 90).
Note
You can only change the name of the current input source
(except for multi channel input sources) using this setting.
58
CAPITAL
DVD
OK RESET
■ Multi CH Assign
(Multi channel assignment)
Use this feature to set the direction of the signals input
into the center, subwoofer and surround channels when a
source component is connected to the MULTI CH INPUT
jacks. If you are inputting 8-channel signals from an
external decoder, use this feature to select jacks for the
additional front signals.
Input Select > MULTI CH > Multi CH Assign >
Volume Trim
Multi CH Assign
Input Channels
This setting is used to select the number of channels input
from an external decoder.
Choices: 6ch, 8ch
Note
If Zone2 Amplifier (page 68) is set to "Internal", no sound is
output from the surround back speakers even if you select "8ch".
In this case, select "6ch" and set the output setting of the external
component to 6 channels.
Front Input
If you selected "8ch" in Input Channels, you can select
analog jacks at which front signals from an external
decoder will be input.
Choices: DVD, DTV, CBL/SAT, VCR1, DVR/VCR2,
V-AUX, CD, CD-R, MD/TAPE
y
This menu item is also available in the front panel display system
options menu (see page 90).
Input Channels
Front Input