Connecting The Antennas - Yamaha RX-V4600 Owner's Manual

CONNECTIONS

Connecting the antennas

Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Indoor FM antenna
(included)
TUNER
FM ANT
75Ω
UNBAL.
GND
AM
ANT
Ground (GND terminal)
For maximum safety and minimum interference,
connect the antenna
ground. A good earth ground is a metal stake driven
into moist earth.
■ Connecting the AM loop antenna
1
Set up the AM loop antenna.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and GND
terminals.
24
AM loop antenna
(included)
GND
terminal to a good earth
3
Orient the AM loop antenna for the best
reception.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A property installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
■ 75-ohm/300-ohm antenna adapter
(U.K. model only)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
3
Cut the lead wire and
remove it.
4
Insert the cable
wire into the slot,
and clamp it with
pliers.
5
Snap the cover into place.
11
Unit:
8
mm
6
Lead wire
Clamp
Clamp
Insert the wire
into the slot