Mounting The Loop Handle - Stihl FS 45 Instruction Manual

English

Mounting the Loop Handle

The loop handle comes in two different
versions.
Version A
Place the friction liner in the loop
N
handle.
10
A
1
6
5
3
4
Fit the loop handle (1) on the drive
N
tube at distance (A) of about 20 cm
(8 in.) from the control handle (2).
Slide the spacer (3) – if supplied –
N
into the loop handle as far as stop.
Insert the screw (4) through the loop
N
handle and the spacer until the
screw head locates in the loop
handle's hexagon recess.
Fit the washer (5).
N
Screw on the star knob (6) and
N
tighten it down firmly.
Adjusting loop handle to most
comfortable position
Loosen the star knob (6).
N
Move the loop handle (1) along the
N
drive tube as required.
Tighten down the star knob (6)
N
firmly.
Version B
Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Line up the loop handle.
2
Use the combination wrench to
N
loosen the screw (1).
Turn the handle to the vertical
N
position.
1
FS 45, FS 45 C