Stihl FS 45 Instruction Manual page 14

English
Thrust Plate
1
3
2
4
The thrust plate (1) is shipped with the
DuroCut 5-2 and PolyCut 6-3. It is only
required for these mowing heads.
STIHL AutoCut 5-2 mowing head,
STIHL AutoCut C 5-2 mowing head
Pull the thrust plate (1), if fitted, off
N
the shaft (2).
STIHL PolyCut 5-2 mowing head,
STIHL FixCut 6-3 mowing head
Slip the thrust plate (1) over the
N
shaft (2) and engage the hex
recess (3) on the external
hexagon (4).
12
Blocking the Shaft
6
6
5
To block the shaft, insert a suitable
N
tool (5) through the holes (6) in the
deflector and thrust plate – turn the
thrust plate back and forth if
necessary.
Fitting Mowing Head with Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
1
Screw the mowing head
N
counterclockwise on to the shaft (1)
as far as stop.
Block the shaft.
N
Tighten down the mowing head
N
firmly.
NOTICE
Remove the tool used to block the shaft.
Removing the Mowing Head
Block the shaft.
N
Unscrew the mowing head
N
counterclockwise.
Fitting Mowing Head without Screw
Mounting
Keep the instruction leaflet for the
mowing head in a safe place.
FS 45, FS 45 C