Mounting The Deflector; Mounting The Cutting Attachment - Stihl FS 45 Instruction Manual

A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 15 cm (6 in)
Slide the handle to the required
N
position.
Tighten down the screw with the
N
combination wrench so that the
handle cannot be rotated on the
drive tube.
FS 45, FS 45 C

Mounting the Deflector

2
1
Push the deflector (1) over the
N
clamp (2) as far as stop.
4
Insert the nut (3) in the hex recess in
N
the deflector – make sure the holes
line up.
Insert the screw (4) and tighten it
N
down firmly.
Mounting the Cutting
Attachment
Placing power tool on the ground
Switch off the engine.
N
Lay your trimmer on its back with
N
the loop handle and shroud pointing
down and the output shaft facing up.
3
English
11