Advertisement
Unsuitable places for installing the station
z Installation underneath a roof or some other mechanical barrier
z Installation facing other direction than South on the Northern hemisphere or North
on the Southern hemisphere.
z Installation between two buildings close to each other.
z Installation on a chimney or heating/air conditioning exhaust
z Installation in a location that is hard to reach, making the station difficult to access.
z Installation in a place where there is a risk of damaging the sensors or the control unit.
z Installation in a place where the weather station sensors readily become dirty.
Installing the console and mounting pole
The weather station is only supplied with two basic telescopic sections of the mounting
pole, to which the actual sensors are attached using plastic or metal mounting arm. This
mounting pole must be attached to the console or a mast. Available is also an optional multi-
functional console Meteo, which is intended for installation of the weather station itself and
various configurations of the sensors and additional accessories. The main advantage of this
system is flexibility in configuration options. Pay close attention to choosing the appropriate
console and its attachment, ensuring maintenance of stable position.
Connecting the station
The connectors are connected to the control unit at the bottom part and those that are
not used must be covered with rubber plugs, which are also supplied with the station.
The weather station is equipped with locking connectors RJ11 and RJ45 for connecting the
sensors and the data cable. OUT1 and OUT2 connectors use the RJ11 connector and close
attention must be paid to ensure it is connected properly using pliers.
User guide for IP Weather Station WARIO ME13
3
Unpacking
Prior to the installation check that all components and hardware are included.
Package contents:
z 2pcs telescopic sections of the mounting pole
z 1pc plastic mounting arm for the wind speed and wind direction sensor
z 1pc wind direction sensor
z 1pc wind speed sensor
z 1pc rain gauge arm
z 1pc rain gauge
z 1pc box with the control unit, radiation shield for the combined
sensors and metal arm
z 1pc arm for attachment of the weather station to the console with a U screw
z 5pcs connection screws
z 2pcs installation clips for the console and telescopic part of the mounting pole
z 4pcs tightening belts
z 1pc power supply (PoE)
z 2pcs LAN data cables
Some of the components such as the install openings or the number of components
connecting the station may be slightly different from the ones depicted on the pictures or
specified in the user guide as there are several types of installation arms, screws and clips
used. Apart from the replacement of the combined sensor radiation shield as part of service,
it is not permitted to manipulate with the control electronics of the weather station in any
way. Non-compliance with this will void the warranty. All connectors and conductors must
be connected while the control unit of the station is turned off.
7
Advertisement
