Advertisement
Wind speed
Setting a condition based on wind speed.
Precipitation
Setting a condition based on precipitation.
Output
Setting a condition based on output status.
Wind gust
Setting a condition based on wind gust.
Apparent temperature
Setting a condition based on apparent temperature.
30
Section events – Mathematical functions
Mathematical functions allow evaluating mathematical functions and binding those to the
condition states. The values from the sensors are multiplied by ten so have no decimal
places. Most recent values are always shown in brackets next to the sensor values.
31
Section events – Condition met / not met
The tab "Not fulfilled" lists the events that result in not fulfilling a condition. The tab "Fulfilled"
lists the events that result when a condition is fulfilled.
User guide for IP Weather Station WARIO ME13
The differences between the Basic and Expert mode are:
Basic mode – the output state can only be specified as ON or OFF, valid for both "Fulfilled"
and "Not fulfilled" state.
Expert mode – same as in case of the Basic mode, but with the possibility to set a particular
time delay.
In Expert mode it is possible to set subsequent actions and conditions once the previous
condition is fulfilled. This allows creating chains of specific actions to be taken for various
scenarios.
32
Section events – Action condition met / not met
If the event for a particular condition is already defined, it is necessary to specify what should
be the action taken when the condition is fulfilled or not fulfilled.
Action – Output setting
Setting condition based on relay output.
Set output to:
Enabling or disabling the output.
Action – Output timing
Selection of output timing.
Select output
Selection of particular output.
State:
Configuration of output state.
25
Advertisement
