Roller Cleaning Paper - Panasonic KV-S2065L Operating Instructions Manual

Cleaning the Unit
Re-attachment of the sensor roller
¥
When the sensor roller is removed while cleaning the inside of the scanner, re-attach it as shown below.
Lower sensor roller:
Attach the roller by placing the gear side to
the left side of the scanner and inserting
both side's bearings into the guide grooves.
•
After attaching, press down on top of the sensor
roller with your finger to confirm if it moves or
not.
Upper sensor roller:
1 Attach the roller by inserting the bearing
of the gear side of the roller into the guide
groove on the left side of the scanner.
•
Match the flat side of the bearing with the
flat side of the guide groove.
2 Hold the shaft on the right side of the
sensor roller, push the tip of the gear, and
slide the sensor roller in the direction of
the arrow Π.
Then attach the roller by inserting the
bearing of the non-gear side of the roller
into the guide groove on the right side of
the scanner.
•
Match the flat side of the bearing with the
flat side of the guide groove.
∫ ∫ ∫ ∫

Roller cleaning paper

Open the bag on the dotted line and take out
the roller cleaning paper.
•
If the bag is left open for a long period of time,
the alcohol will evaporate.
Please use the
immediately after opening the bag.
The roller cleaning paper (Model No. KV-SS03) is available from the dealer where you
§
purchased your scanner.
For supplies and accessories: Call 1-800-346-4768 (U. S. A. only) or your dealer.
40
roller cleaning paper
Bearing
Gear
Guide groove
Please attach the right side bearing in the same way.
Sensor roller
2
1
Gear
Dotted line
Sensor roller
Bearing
Guide groove