Panasonic KV-S2065L Operating Instructions Manual page 25

Imprinter setting menu (by pressing the IMPRINT key)
Both a pre-imprinter and post-imprinter can be installed at the same time. However, the operator may only use
one imprinter at a time. If both of the imprinters are installed, you can set the following conditions.
Number, item and default display
•
Pressing the 3 key will change to the
next mode.
•
Pressing the 4 key will change to the
previous mode.
01 Setting the pre-imprinter data
0 1 . P r e I m p r i n t
•
This setting can be done only when a
pre-imprinter is installed.
02 Setting the pre-imprinter position
0 2 . P r e P
•
This setting can be done only when a
pre-imprinter is installed.
03 Setting the pre-imprinter font style
0 3 . P r e F o n t
•
This setting can be done only when a
pre-imprinter is installed.
•
H o s t
Host :
Count :
By pressing the 1 key or the 2 key, you can specify the line
where printing starts from the top of the document. If "0"
character is set, printing starts from 10.0 mm.
o s i t i o n
The millimeter value displayed is an approximation.
H o s t
The length per character varies, depending on the 04 orientation
setting.
Character: 0 - 72
•
H o s t
Bold :
Normal:
Pressing the 1 key or the 2 key will change to another value.
Host Count
Printing will be done according to the host computer.
Printing will be done according to the counter in the
"Select counter displayed on the LCD".
0 2 . P r e
1 C h a r
90°or 270°: 2.40mm per character
0°or 180°: 3.46mm per character
In this example, printing starts at 12.4 mm (approx. 1/2 in.)
from the top of the paper. The number 12.4 can be changed
from 10.0 to 182.8 by pressing the 1 key or the 2 key.
Top of the paper
10mm (Default)
Approx.
13/32 in.
Top of the
printout
Host Bold Normal
2-dot font
1-dot font that can increase the ink lifetime longer than
Bold fonts.
Display Panel Instructions
Contents
P o s i t i o n
1 2 . 4 m m
Top of the paper
12.4mm
Approx.
1/2 in.
Top of the
printout
25