Panasonic KV-S2065L Operating Instructions Manual page 18

Display Panel Instructions
Others menu
No. Item
01 Checking the version
02 Setting the buzzer
03 Setting the SCSI ID
04 Setting the terminator
Setting the transfer
05
rate
Checking the roller
cleaning warning
06
Clearing the roller
cleaning warning
Checking the roller
modules replacement
warning
07
Clearing the roller
modules replacement
warning
Setting the product
08
ID
Setting the sleep
09
mode
18
LCD display
Displays the firmware version of the mechanical
control, pre-imprinter or post-imprinter. If an optional
Version
imprinter is not installed, the imprinter version will not
be displayed.
Selects whether the buzzer is turned on or off. If
selection is in the "ON" position:
When pressing a key, one short beep will be heard.
Buzzer
When there is an error, 5 short beeps will be heard.
When scanning is completed correctly, one long beep
will be heard.
SCSI ID Sets the SCSI ID number.
Sets "Enable" or "Disable".
Terminator "Enable" : If last device on chain.
"Disable" : If between devices.
•
Changes the maximum value of the synchronous
transfer rate of the SCSI interface.
•
Transfer Rate
Lower the synchronous transfer rate to 10 Mbytes/
sec. if the computer has failed to recognize the
scanner or the scanner fails to operate properly.
The alarm tells you it is time to check the roller. If it is
Clean Roller near 100%, clean the roller. See "Cleaning the Unit" on
page 36.
Clean Roller Clear the "Clean Roller Warning ≤≤ %" display.
The alarm tells you the roller needs to be changed. If it
is near 100%, replace the paper feed roller module and
Replace Roll.
retard roller module. See "Replacing Consumables" on
page 41.
Replace Roll. Clear the "Replace Roll. Warning ≤≤ %" display.
Selects the product ID. The product ID setting depends
on the host computer scanner application you are
Product ID
using. Allows scanner to emulate other Panasonic
scanners.
Sleep Mode Sets the time until sleep mode turns ON.
Contents Page
27
28