Graco xtreme Instruction Manual page 21

Prime/Flush
1. See F . 5. To enter Prime/Flush mode, press any
IG
key to wake up the display, then press
Prime/Flush symbol will appear flashing in the dis-
play and the LED will flash
2. While in Prime/Flush mode, runaway protection is
disabled and the batch totalizer (BT) will not count.
3. To exit Prime/Flush mode, press any key to wake up
the display, then press
bol will disappear from the display and the LED will
stop flashing.
Counter/Totalizer
See F . 5. The last digit of the batch totalizer (BT) rep-
IG
resents tenths of gallons or liters. To reset the totalizer,
press any key to wake up the display, then press and
hold for 3 seconds.
NOTE: If flow rate is set to
ers will display the number of pump cycles.
311164M
. The
.
. The Prime/Flush sym-
both totaliz-
/min,
Display
See F . 5. The display (Y) will turn off after 1 minute of
IG
inactivity in Run mode or 3 minutes in Setup mode.
Press any key to wake up the display.
NOTE: DataTrak will continue to count cycles
when display is off.
Diagnostics
DataTrak can diagnose several problems with the pump.
When the monitor detects a problem, the LED (W, F
5) will flash and a diagnostic code will appear on the dis-
play. See Table 3.
To acknowledge the diagnosis and return to the normal
operating screen, press
and once more to clear the diagnostic code screen.
DataTrak Operation
once to wake up the display,
.
IG
21