Table of Contents
Advertisement
Chapter 2 Preparations
1.7.4
Removal
Remove a DIMM in the following procedure.
1.
Refer to steps 1 to 5 in Chapter 2 (1.3 Overview of Installation and Removal for preparations.
2.
Rotate both levers of the target DIMM
slot outward.
The DIMM is unlocked
3.
Remove the DIMM by pulling it out from
the slot in a straight direction.
4.
Assemble the server.
5.
Turn on the server and confirm that no error messages are displayed on POST. If any error message
is displayed, refer to Chapter 3 (1. Post Error Message) in "Maintenance Guide".
6.
If you replaced a broken DIMM, select Yes in Memory Configuration-Memory Retest of the
Advanced menu.
After that, select Save Changes and Exit to reboot.
7.
If an OS has been installed, change the paging file size.
If your OS is Windows, refer to "Installation Guide (Windows)".
Note
When removing a defective DIMM, check error messages displayed at POST or
ESMPRO and check the DIMM slot where the defective DIMM is installed.
At least one DIMM needs to be installed for the server to operate.
Important
Applying too much pressure on a DIMM or pulling a DIMM at an angle may
break the DIMM or slot. Gently pull it straight out of the slot.
Express5800/GT110d User's Guide
1. Installing Internal Optional Devices
49
Advertisement
Table of Contents
