Table of Contents
Advertisement
•
Touch up any paint nicks. See your dealer for touch‑up paint.
•
Spray Quicksilver or Mercury Precision Lubricants Corrosion Guard on
external metal surfaces (except corrosion control anodes).
Tube Ref
Description
No.
Corrosion Guard
120
Protecting Internal Engine Components
•
Remove the spark plugs and add approximately 30 ml (1 oz.) of engine oil
or inject a five second spray of storage seal inside of each cylinder.
•
Rotate the flywheel manually several times to distribute the oil in the
cylinders. Install spark plugs.
•
Change the engine oil.
Gearcase
•
Drain and refill the gearcase lubricant (refer to Gearcase Lubrication).
Positioning Outboard for Storage
Storing the outboard in a tilted position can damage the outboard. Water
trapped in the cooling passages or rain water collected in the propeller
exhaust outlet in the gearcase can freeze. Store the outboard in the full down
position.
•
To prevent problems which can be caused by oil entering the cylinders
from the sump, only store the outboard in one of the three positions
shown.
a
STORAGE
NOTICE
THIS SIDE UP
b
c
39056
Where Used
External metal surfaces
NOTICE
a -
Upright position
b -
Tiller handle down
c -
Front side down
98
Part No.
92-802878 55
eng
Advertisement
Table of Contents
