Using The Remote Terminal - Panasonic PT-L750U R Operating Instructions Manual

Using the remote terminal

Using the remote terminal built into this projector, it is possible to operate the
projector from an external location from where infrared remote control signals
cannot be received, by using a remote control panel.
Pin assignment and control
6 9
1 5
D-Sub 9-pin (female)
external appearance
Short pin 1 and pin 9 when controlling.
#Power ON/OFF
Pin No.
$ - #
Short
Lamp ON
$Switching the input mode
Pin No.
% - #
Open
' - #
Open
( - #
Open
Input Signal RGB1
NOTE:
B The POWER, RGB and VIDEO buttons on the remote control unit and
projector will not operate when pins 1 and 9 are shorted. RS-232C
commands will also be ignored. If the projector is connecting a personal
computer using an optional wireless card or LAN card, the "POWER" or
"SWITCH INPUT MODE" will not function.
B Do not short pins. 1, 2, 3, 5, or 6 when pin 9 is open. If this is done, the
projector will ignore signals from the remote control unit.
Pin Signal Name
#
GND
$
POWER
%
INPUT SEL3
&
'
INPUT SEL1
(
INPUT SEL2
)
*
+
ENABLE
Setting
Open
OFF (standby)
Open Short
Short Open
Open Short
RGB2 RGB3
Description
Ground
Power ON
Input signal select3
NC
Input signal select1
Input signal select2
NC
NC
Enables remote terminal control
Setting
Short Short
Open Short
Open Open
VIDEO S-VIDEO
Open
Open
Short
DVI
57