Back Color; Front/Rear; Desk/Ceiling; Lamp Power - Panasonic PT-L750U R Operating Instructions Manual

BACK COLOR

This sets the colour which is
projected onto the screen when no
signal is being input to the projector.

FRONT/REAR

This setting should be changed in
accordance with the projector
setting-up method.
Set to "FRONT" when using a
normal reflective screen with the
projector positioned in front of the
screen, and set to "REAR" when
using a translucent screen with the
projector positioned behind the
screen.

DESK/CEILING

This setting should be changed in
accordance with the projector
setting-up method.
Set to "DESK" when setting up the
projector on a desk or similar, and
set to "CEILING" when suspending
the projector from the ceiling using
the ceiling bracket which is sold
separately.

LAMP POWER

This setting changes the lamp
brightness. When set to "LOW", the
luminance of the lamp is reduced, but
the projector uses less power, and
the operating noise is also reduced.
This can help to extend the lamp's
operating life. If using the projector in
small rooms where high luminance is
not required, it is recommended that
you set the LAMP POWER to "LOW".

LAMP RUN TIME

This setting displays the usage time
for the lamp unit which is currently
being used. If the lamp unit is
replaced in the way described on
page 64, the cumulative usage time
for the lamp unit will be reset to
zero.
NOTE:
B The lamp's operating life varies
depending on the usage conditions
(such as the LAMP POWER
setting and the number of times
the power is turned on and off).

FAN CONTROL

If using of this projector at high
elevations (above 1 400 m), set the
FAN CONTROL to "HIGH".

WEB CONTROL

(PT-L780NTU only)
To control the projector with a
personal computer by means of a
wireless or wired network using an
optional wireless or projector LAN
card, set WEB CONTROL to "ON".
To prevent it, set to "OFF".

WEB STANDBY

(PT-L780NTU only)
To turn on and off the power with a
personal computer by means of a
wireless or wired network using an
optional wireless or projector LAN
card, set the WEB STANDBY to
"ON".
When the WEB STANDBY is set to
"ON", the cooling fan operates and
the power indicator on the projector
flashes slowly in red.
47