Remote Control Unit; Projector Control Panel - Panasonic PT-L750U R Operating Instructions Manual

Remote control unit

0 1

Projector control panel

$
#
RGB INPUT
POWER AUTO SETUP
(
STANDBY(R)
ON(G)
)
– +
FOCUS
.
MENU
– +
ZOOM
/
+
# Power indicator
(pages 30, 31
This indicator illuminates red when
the MAIN POWER switch is turned
on (standby mode), and illuminates
green when the power is turned on
and a picture starts to be projected.
(PT-L780NTU only)
When the WEB STANDBY is set
to "ON", the cooling fan operates
and the power indicator on the
projector flashes slowly in red.
$ RGB INPUT indicator
This indicator illuminates when a
signal is input into the connector
that is selected with the input
select buttons.
% LAMP indicator (page 61)
This indicator illuminates when it is
time to replace the lamp unit. It flashes
if a circuit abnormality is detected.
& Input select (RGB, VIDEO)
buttons (page 30)
' TEMP indicator (page 60)
This indicator illuminates if an
abnormally high temperature is
detected inside the projector or
16
2
& '
%
TEMP
LAMP
INPUT
VIDEO RGB SHUTTER
*
ENTER
, -
and 47)
POWER
(
RGB
&
VIDEO
PAGE
3
,
-
R-CLICK
FREEZE SHUTTER
6
7
8
FUNC1
9
Computer
around it. If the temperature rises
above a certain level, the power
supply will be turned off
automatically and the indicator
will illuminate or flash.
( POWER button
(pages 30 and 31)
) AUTO SETUP button
(pages 30 and 62)
If this button is pressed while a
picture is being projected, the
projection settings will be
adjusted automatically in
accordance with the signal being
input. In addition, the angle of tilt
of the projector will be
automatically detected and
adjusted in order to correct any
keystone distortion. ("AUTO
SETUP" will appear on the
screen during adjustment.) Set
"AUTO KEYSTONE" in the
OPTION menu to "OFF" to
prevent any deterioration of the
picture as a result of keystone
correction. However, keystone
distortion may not be corrected
4
AUTO
SETUP
)
LASER
5
MENU
+
ENTER
*
:
Pro jector
;