If Wireless Communication Has Already Been Established Between Pcs (In Ad Hoc Mode) - Panasonic PT-L750U R Operating Instructions Manual

If wireless communication has already been
established between PCs (in ad hoc mode)
In this case, it is required to make settings so that direct wireless communication will
be available between the personal computers and the projector in ad hoc mode using
the wireless cards that are currently used in the PCs.
For details of setting the projector, refer to "Setting the projector" on page 104.
Personal computer
Typical setting
Parameters
IP address
Subnet mask
Mode
Channel
Notes:
• The settings of the PC are available without modification. However, give the same
WEP settings to the projector as the PC because the projector will also support
WEP if the WEP function is enabled on the PC.
If the WEP function is disabled, data encryption is also disabled. Therefore, it is
recommended to take measures for data protection such as setting a password in
folder sharing. For details, please consult your network administrator.
• Compatibility with other cards than the optional wireless card (ET-CDWL1) is not
guaranteed.
100
R
Projector
Setting of the projector
Assign an IP address that is different from that of PC.
Example: If the IP address of the PC is 192.168.10.11, assign
an address such as 192.168.10.12 to the projector.
Use the same settings as the PC.
AD HOC
Use the same setting as the PC.
Personal computer