Table of Contents
Advertisement
Adjusting the picture to the desired setting
You can adjust the picture settings for any of the input signal sources selected according to the procedure on page 18.
The items which can be adjusted vary depending on the type of input signal. The adjustment procedure below
describes the on-screen displays when a signal is being input to the S-VIDEO IN terminal or the VIDEO IN terminal.
Adjustment procedure <for the COLOR setting>
1. Press the MENU button to display the MENU screen.
2. Press the " " and " " buttons to select "PICTURE".
3.
Press the "<" and ">" buttons to display the PICTURE screen.
4.
Press the " " and " " buttons to select "COLOR".
NOTE:
If the STD (Standard) button is pressed while the PICTURE screen at right is
being displayed, the letters "STD" will be displayed in yellow in the top-right
corner of the screen and all settings other than the TV-SYSTEM setting will be
reset to the factory pre-settings. Furthermore, the values and bar displays for
items which have returned to the factory pre-settings will be displayed in yellow.
Press the "<" and ">" buttons to display the COLOR individual adjustment screen.
5.
6.
Continue pressing the "<" and ">" buttons to adjust the color. The current setting
will be displayed on the screen by numerals and a bar.
The adjustment operation and the changes made will vary depending on which
adjustment item is selected. Refer to the table below for details.
Adjustment Item
Press the ">" button.
COLOR
Press the "<" button.
Press the ">" button.
TINT
Press the "<" button.
Press the ">" button.
BRIGHT
Press the "<" button.
Press the ">" button.
CONTRAST
Press the "<" button.
Press the ">" button.
SHARPNESS
Press the "<" button.
NOTE:
If approximately five seconds pass without any buttons being pressed while an individual adjustment screen is
being displayed, the display will return to the PICTURE screen.
Press the MENU button to return to the PICTURE screen or to clear the MENU screen.
If the STD (Standard) button is pressed while one of the individual adjustment screens is being displayed, the
value and the bar display will be appeared in yellow and only the item displayed will be reset to the factory pre-
setting.
Refer to page 20 for details on the TV-SYSTEM setting which is displayed in the PICTURE screen, and to the
following page for details on the W-BAL R/G/B setting which is displayed when RGB signals are being input.
Furthermore, refer to page 19 for details on the SIGNAL MODE setting when RGB signals are being input.
If a PAL or SECAM signal is being input, the TINT item will not appear on the screen.
Adjustment function display
Numeric adjustment level display
Button
Adjustment Details
The color becomes darker.
The color becomes lighter.
Flesh tones become greenish.
Flesh tones become reddish.
The screen becomes brighter.
The screen becomes darker.
The screen becomes brighter
and the picture becomes darker.
The screen becomes darker and Min. value 0
the picture becomes lighter.
The picture quality becomes sharper.
The picture quality becomes softer.
Adjustment Range
Max. value 63
Min. value 0
Max. value 63 NTSC, NTSC 4.43 (S-
Min. value 0
Max. value 63
Min. value 0
Max. value 63
Max. value 63
Min. value 0
22
Bar display
Remarks
S-VIDEO/VIDEO only
VIDEO/VIDEO)only
S-VIDEO/VIDEO only
Advertisement
Table of Contents
