Table of Contents
Advertisement
Adjusting the volume
The volume can be adjusted by pressing the VOL (+/-) buttons on the remote control unit.
Remote control unit
Turning off the sound
If the MUTE button on the remote control unit is pressed, "MUTE" will be displayed on the screen as shown in the
illustration below and the sound will be muted. If the MUTE button is pressed once more, the on-screen display will
be cleared and the normal sound volume will be restored. The volume output level will remain displayed on the
screen for approximately three seconds.
Remote control unit
Resetting adjustment values to the factory pre-settings (standard values)
If the STD (Standard) button on the remote control unit is pressed while the PICTURE screen, POSITION screen,
AUDIO screen or one of the individual adjustment screens is being displayed, the adjustment settings being
displayed will be reset to the factory pre-settings.
Remote control unit
If the "+" button is pressed, the volume will increase,
and if the "-" button is pressed, the volume will
decrease.
NOTE:
If these buttons are pressed while the on-screen display
for another function is currently on the screen, the
volume will still be adjusted but the current volume
setting and the volume bar display will not appear.
The volume can also be adjusted from an on-screen
display menu. Refer to page 24 for details on how to do
this.
The volume output level will remain displayed on the
screen for approximately three seconds.
NOTE:
If the MUTE button is pressed while the on-screen display
for another function is currently on the screen, the volume
will still be muted but the "MUTE" on-screen display will not
appear.
If the power supply is turned off or either of the VOL (+/-)
buttons is pressed, the mute setting will be canceled.
It is also possible to have the picture turn off together with
the sound when the MUTE button is pressed. Refer to page
32 for details on how to change this setting.
When the picture has been turned off in this way, the words
"PICTURE MUTE" will be displayed on the screen.
If the STD (Standard) button on the remote control unit is
pressed while the PICTURE screen, POSITION screen or
AUDIO screen is being displayed, the letters "STD" will be
displayed in yellow in the top-right corner of the screen and
all items displayed will be reset to the factory pre-settings.
NOTE:
However, the "TV-SYSTEM" and "SIGNAL MODE" settings
in the PICTURE screen and the "VOLUME" setting in the
AUDIO screen will not return to the factory pre-settings.
If the STD (Standard) button on the remote control unit is
pressed while one of the individual adjustment screens is
being displayed, the value and the bar display will be
appeared in yellow and only the item displayed will be reset
to the factory pre-setting.
21
Advertisement
Table of Contents
