Table of Contents
Advertisement
Replacement procedure
NOTE:
If the lamp unit is replaced after it has been used for more than 2,000 hours, the projector will switch to standby
mode after approximately 10 minutes of operation. Steps 7. to 11. on the following page should thus be
completed within 10 minutes.
1. Disconnect the power cord plug from the wall outlet and check that the area around the lamp unit has cooled
down.
2. Use a Phillips screwdriver to remove the screw which is securing
the lamp unit cover at the right side of the projector, and then
remove the lamp unit cover.
NOTE:
Read the CAUTION on the lamp unit cover before continuing.
3. Turn the fixing screw for the lamp unit by hand until it turns freely.
CAUTION:
The lamp unit will be hot after it has been used, and you might
receive burns if you touch it while it is still hot.
4. Hold the handle which is attached to the lamp unit and gently pull
the lamp unit out from the projector.
5. Insert the new lamp unit, while making sure that the direction of insertion is correct, and then turn the fixing
screw for the lamp unit by hand until it is securely tightened.
NOTE:
Insert the lamp unit so that the fixing screw for the lamp unit is facing downward.
6. Securely install the lamp unit cover, and then use a Phillips
screwdriver to securely tighten the fixing screw for the lamp unit
cover.
NOTE:
Be sure to install the lamp unit and the lamp unit cover securely. If
they are not securely installed, it may cause the protection circuit
to operate so that the power cannot be turned on.
Lamp unit cover
Fixing screw for the lamp unit
42
Fixing screw for
the lamp unit cover
Handle
Advertisement
Table of Contents
