Table of Contents
Advertisement
Example of connection to a computer
Computer
To audio
Macintosh adapter
output
(accessory)
terminal
D-SUB HD 15-pin
To video
(male)
output
D-SUB HD
connector
15-pin (male)
D-SUB HD 15-pin
(male)
VGA cable
(accessory)
Computer
NOTE:
If the mouse connector on the projector is connected to the mouse connector on the computer with the
accessory or separate mouse cable, you can then use the remote control unit in place of the computer' s mouse.
However, this function operates only when input to the RGB 1 connector has been selected. For further details,
refer to page 35.
If you wish to use the infrared mouse function, turn on the main power to the projector before turning on the
personal computer.
If using a personal computer with a suspend/resume function, the infrared mouse function may not operate until
the computer is restarted.
Refer to the data on page 19 for details of what kinds of computers can be connected to the projector. If
computers other than those listed here are used, correct operation cannot be guaranteed.
The signal which is connected to the RGB IN connector for RGB 1 or RGB 2 will be output from the RGB OUT
terminal. However, no signal is output from the RGB OUT terminal if the input signal is switched so that RGB 1
and RGB 2 are no longer selected, or if the projector power is turned off.
Monitor
To video
input
connector
To video
output
connector
To audio output terminal
To mouse connector
Audio system
D-SUB
9-pin
13-pin
(female)
(male)
Mouse cable for PS/2
(accessory)
34
Pin configuration and signal
names for RGB connector
5
1
10
6
15
11
Signal name
Pin No.
1
R
2
G/G-SYNC
3
B
NC
9
SDA
12
13
HD/SYNC
14
VD
SCL
15
4-8,10, and 11
GND
NOTE:
Pin No. 12 and pin No. 15
on 15-pin connectors will
only work if the computer
supports them.
Computer for
control use
Advertisement
Table of Contents
