Table of Contents
Advertisement
Adjusting the sound to the desired setting
You can adjust the volume and balance to the desired settings.
Adjustment procedure <for volume adjustment>
1. Press the MENU button to display the MENU screen.
2. Press the " " and " " buttons to select "AUDIO".
3. Press the "<" and ">" buttons to display the AUDIO screen.
NOTE:
If the STD (Standard) button is pressed while the AUDIO screen at right is being
displayed, the letters "STD" will be displayed in yellow in the top-right corner of
the screen and only the BALANCE setting will be reset to the factory pre-
setting. Furthermore, if the BALANCE setting has returned to the factory pre-
setting, the value and the bar display for the BALANCE setting will be displayed
in yellow.
4. Press the " " and " " buttons to select "VOLUME" .
To adjust the balance, select "BALANCE" instead.
5. Press the "<" and ">" buttons to display the VOLUME individual adjustment
screen.
6. Continue pressing the "<" and ">" buttons to adjust the volume setting. The
current setting will be displayed on the screen by numerals and a bar.
The adjustment range is between 0 and 63.
(However, the adjustment range for the
balance setting is -32— +31.)
While "VOLUME" is selected, the volume of
the sound coming from the built-in speakers
and the output level of the signal from the
AUDIO OUT terminal will change.
While "BALANCE" is selected, the left and
right balance of the sound coming from the
built-in speaker and the output level of the
signal from the AUDIO OUT terminal will
change.
NOTE:
If approximately five seconds pass without any buttons being pressed while an individual adjustment screen is
being displayed, the display will return to the AUDIO screen.
Press the MENU button to return to the AUDIO screen or to clear the MENU screen.
If the STD (Standard) button is pressed while the BALANCE individual adjustment screen is being displayed, the
value and the bar display will be appeared in yellow and only the BALANCE setting will be reset to the factory
pre-setting.
The "VOLUME" adjustment made from the AUDIO screen has the same effect as pressing the volume
adjustment buttons (VOL +/-) on the remote control unit.
If the volume level is set to "0" , no sound will be output from the AUDIO OUT terminal.
Adjustment func-
tion display
Numeric adjustment
level display
24
Bar display
Advertisement
Table of Contents
