H3C S5120-EI Series Operation Manual page 72

Configuring GigabitEthernet1/0/4... Done.
[DeviceA-Bridge-Aggregation2] quit
2) Configure Device B
Configure Device B as you configure Device A.
3) Verify the configurations
# Display the summary information about all aggregation groups on Device A.
[DeviceA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG
Interface Mode
-------------------------------------------------------------------------------
BAGG1 S
BAGG2 S
The output above shows that link aggregation groups 1 and 2 are both load-sharing-capable Layer 2
static aggregation groups and each contains two selected ports.
# Display all the group-specific load sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode interface
Bridge-Aggregation1 Load-Sharing Mode:
source-mac address
Bridge-Aggregation2 Load-Sharing Mode:
destination-mac address
The output above shows that the load sharing criterion for link aggregation group 1 is the source MAC
addresses of packets and that for link aggregation group 2 is the destination MAC addresses of
packets.
Partner ID
none
none
1-21
Select Unselect Share
Ports Ports Type
2 0 Shar
2 0 Shar